PENGUJIAN DAN PERAWATAN MESIN GRANULAR

Main Article Content

Zul Ihsan Robby Gunawan Eka Sunitra Rivanol Chadry Yuli Yetri

Abstract

This paper discusses the granulator machine testing process. This test aims to determine the process of occurrence of granular. Granular pellets are one form of feed pellets, granular (rounded) and light in weight. Granular pellets are not easy to sink but are easily broken down in water. This type of pellet is made without going through the process of pressing, so that it can produce feed grains that are light weighted, not easily submerged but easily decomposed in water. The goal is to determine the optimal state of the granulator machine with three angular tilt positions, it can perform maintenance on the granulator machine. The granulator machine testing process is carried out by means of the plate angle measurement process, the water mixture measurement process, the plate speed measurement process. Material used for the testing process uses flour and water. While the tools used in the granulator machine testing process are spray, 14 key, sieve, and container. After testing at 3 angles at an angle of 25o, angle of 30o and angle of 35o the authors conclude that this machine can produce small granules at a slope of 250 with an engine speed of 17 rpm and average weight of granular which is produced 236 grams. While the results of hourly 3 kg / hour.

Downloads

Download data is not yet available.

Article Details

How to Cite
Ihsan, Z., Gunawan, R., Sunitra, E., Chadry, R., & Yetri, Y. (2020). PENGUJIAN DAN PERAWATAN MESIN GRANULAR. Jurnal Energi Dan Teknologi Manufaktur (JETM), 3(02), 19-24. https://doi.org/https://doi.org/10.33795/jetm.v3i02.54
Section
Articles

References

[1] Warji, Lanya, Budianto, Hardika, Gerry. 2013. Rancang Bangun dan Uji Kinerja Mesin Granulator Beras Jagung. Jurnal Teknik Pertanian Lampung Vol. 2, No. 2: 67- 76.
[2] Firdausi, Arif. 2013. Mekanika dan Elemen Mesin. Kementerian Pendidikan dan Kebudayaan.
[3] Prajitno, 2001. Elemen Mesin Pokok Bahasan Transmisi Sabuk dan Rantai. Jurusan Teknik Mesin UGM.
[5] Sularso.1997. Dasar Perencanaan dan Pemilihan Elemen Mesin. PT. Pradya Paramita, Jakarta
[6] Chaudhari, Chetan P. 2015. A Study Of Bearing And Its Types. International Journal of Advance researches in Science ang Engineering IJARSE, Vol. No.4 Speciallis Issue (01) March 2015, 1674-1681.
[7] Djumhariyanto, Dwi, Sidartawan Robertus. 2013. Desain Dan Pembuatan Mesin PAN Granulator Pupuk Organik Berkapasitas 250 kg/jam. Prosiding Seminar Nasional Teknik Mesin 2017 Jurusan Teknik Mesin Fakultas Teknik Universitas Jember, hal 12-15.
[8] Daya, Mohamed Ben, Duffuaa, Salih O. 2009. Handbook of Maintenance Management and Engineering. Springer Dordrecht Heidelberg London NewYork